WQB Repair System
The new WQB Repair System upgrades the Weller product
range in the SMD repair tool sector. A well thought-out
design concept combines reliability and maximum process
control with ease of use and technically mature detail
solutions. Useful accessories increase the possible
uses of this repair work station.
For the universal circuit board repair of SM components,
it is necessary to effectively pre-heat the circuit
board from below, and from above to precisely heat
the components to be repaired to the reflow temperature,
as well as to reliably control the process. On the
WQB 3000 the temperature-regulated 2-zone infrared
bottom heater provides rapid warm up and homogeneous
substrate temperatures. The hot gas top heater, with
digital control electronics for temperature monitoring
and regulation of the air flow rate, facilitates the
finely metered supply of heat to the components. A
temperature sensor placed directly in the hot gas nozzle
efficiently regulates the top heater and thus provides
maximum process control.
For the repositioning of components after desoldering,
two system versions are available:
1. The WQB 3000OPS with the camera aided positioning
system. Regulation and control via PC
2. The WQB 3000. The positioning ensured by the
proven and patented template system from Weller.
Control is via the programming unit, which can store up to 30, programmed profiles.
Alternatively, the WQB 3000 can be controlled with the Weller software package
“WQB 3000 CONTROL” via a PC.
Download
Sales Literature
Download Exploded
Drawings and Operating Instructions
